PDA

View Full Version : Enduro setup



loosenuts77
06-07-2002, 12:50 PM
Paul,

We have an enduro later this month. The track is a custom 175' track( i set up a car for this track same as a tri-oval, if that helps)
The guidelines are:

4 inch flexi chassis(stamped steel)
7/8 inch Mx tires
1/2 inch fronts.
rally car body
11 tooth pinion, 30 or 31 spur.
1/8 inch axle, 48 pitch
cheata or falcon motor.( we get our racing motor the day we race)


What do you recomend?
I was thinking of the felxi 2 with a flexi car pan.
or the light flexi3 with the light pan. i wanted to use these over the t-flex ot flexi 1 cause of the square bushings. im probably running them up and back. what would u recomend?

Paul Ciccarello
06-11-2002, 09:34 AM
I think that the flexi 2 center with the flexi 1 pan would be a good choice.

Paul

Kiwi Racer
06-11-2002, 08:03 PM
loosenuts can u post a picture of the rally body. im extremely interested in getting some

loosenuts77
06-11-2002, 09:09 PM
i might be able to after the enduro. im gonna try to start a webste for racing i my area. they should be there. i dont know where else to find a pic of one. sorry kiwi

loosenuts77
06-26-2002, 11:28 AM
I put itas an atachment. its prety neat. havemak off the stars though. then paing the rest blue. should look pretty neat afterwards.

Kiwi Racer
06-28-2002, 12:38 AM
loose it doesnt work

ryan540
06-28-2002, 02:50 AM
ha, it kinda works. There is a sidepan a front wheel and a bit of the rear.

loosenuts77
06-28-2002, 05:37 AM
ok then, how do post a picture?

ryan540
06-28-2002, 02:23 PM
just how u did it but make sure all of the photo is there this

smallcars
07-01-2002, 03:30 PM
the bodies used where jk's.