PDA

View Full Version : S16d Magnet Clips



ryan540
11-14-2002, 11:39 PM
Everytime I try and get the magnets clips in a S16d out they bend and i can't use them again. How do i get them out without bendin them???

Paul Ciccarello
11-15-2002, 03:32 AM
I push the magnets out with a screwdriver and then the clips come out with them. To put them back in, first put the magnets in and then put both clips in 1/32-1/16. Then take the can, clips, and magnets all together and push them against the table all at once. Make sure you do it evenly and they will not bend. It is definately an art that will take some practice.

Paul

Mike Wyatt
11-15-2002, 04:03 AM
I get them started, then put a screwdriver through the vent holes and the holes in the clips. Place thumb on the can bushing, and using index and middle finger, "pull" both clips in at the same time.

Bobhardt
11-15-2002, 06:07 PM
Same here Mike.

Gill A
11-16-2002, 03:02 AM
Ryan, if you are in need of some replacement clips drop me a line I have heaps.

HOBBIES PLUS
NZ

ryan540
11-16-2002, 03:10 AM
cool, thanks gill