PDA

View Full Version : Mush Button



hesketh
06-27-2002, 07:07 AM
Can you explain how to fabricate a mush button for an external resistor controller and what parts would be required?

Thanks,
Paul Kovich

DifalcoDesign
06-27-2002, 07:50 AM
I will take this one for you Paul. On electronic controllers you are just switching low power while on resistor controller you switch the full car power. You would have to use a switch to interrupt the two wires that go to resistor that changes to lower sensitivity (Fast and medium positions on my controllers). You would need switch on each wire and it would have to be rated at least 6 amps.

I have never done one on external controller. Mush button is one of the advantages of electronic units. Hope this helps, Jim Difalco.

hesketh
06-28-2002, 11:03 AM
Jim I put a follow up question to you in the Tech Tips area on this topic.
Thanks ,
Paul Kovich