Kelly G-2 Cans

[Chasegtp1590]

Hey Monty was the C-Can Slug hard to get in the g-2 cans? It looks like im gonna have a hard time gettin it in there, how should i go about doing this?

[Alleynyc]

Kelly makes there own c-can tool. I polished mine down a little and it fits.
-Al

[Chasegtp1590]

Hmmm it wasnt as hard as it looked, the can went on easily, on a regular C-Can Slug. :D

[Monty @ B.O.W.]

Hey guys, thanx for answering first ;-) . Anyway, the G2 Kelly can is no more difficult to straighten than other Kelly cans, which is to say not too bad at all now that they are plated.

On the occasional can that IS tight, and you fear busting the brazed joint (a reasonable fear, I might add), I've had some success with inserting the slug partway, working the portion of the can that IS over the slug, then working furthur by small increments. I actually haven't broken one in quite a while.