.

.

Search:

Type: Posts; User: dominator

Page 1 of 15 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    13
    Views
    6,150

    It's going to Fast Tracks in PA

    It's going to Fast Tracks in PA
  2. Replies
    6
    Views
    2,041

    That's SWEET!

    That's SWEET!
  3. Thread: sparks

    by dominator
    Replies
    3
    Views
    1,119

    Springs being too weak. Be sure to not rev the...

    Springs being too weak. Be sure to not rev the motor high when its on the power supply as this can also cause arching as nd hurt the arm ad well as performance. If the car is running hot try a...
  4. Replies
    17
    Views
    4,309

    Jeff great to hear you are setting up a raceway...

    Jeff great to hear you are setting up a raceway in Maine especially with the Lou's old UK Black! I am on the BOD for New England Retro Racing (NERR) series. Here is a link to our website along with...
  5. Replies
    8
    Views
    2,299

    Proslot 16-D set up with an american arm geared...

    Proslot 16-D set up with an american arm geared with a 7 tooth pinion should prove to me more than enough power and have plenty of break.
  6. Replies
    16
    Views
    4,453

    It's a flat track so gear low like 9:37. Check...

    It's a flat track so gear low like 9:37. Check your guide spacing, if you don' t have a cut down guide already put one of those on and start with .010 spacing under the guide. Put the car on the...
  7. Replies
    20
    Views
    5,840

    I'm 99% sure that is the same track that was in...

    I'm 99% sure that is the same track that was in NH and can attest that it is a blast to race on.
  8. Replies
    4
    Views
    3,026

    Body mount looks good Jim!

    Body mount looks good Jim!
  9. Replies
    7
    Views
    1,640

    Not 100% positive but I think it's a Rigen.

    Not 100% positive but I think it's a Rigen.
  10. Replies
    35
    Views
    9,534

    Only 9 laps between 1st and 5th. It doesn't get...

    Only 9 laps between 1st and 5th. It doesn't get any closer than that in Eurosport!
  11. Thread: Chassis ID??

    by dominator
    Replies
    4
    Views
    1,822

    The 2nd one is a C-1 chassis. These were run...

    The 2nd one is a C-1 chassis. These were run back in the 90's.
  12. This would not perhaps be the pinball arcade in...

    This would not perhaps be the pinball arcade in Pelham would it?
  13. Cut a small hole in one side of one of the pans...

    Cut a small hole in one side of one of the pans to make it easier to slide the wire in and out for both straightening and tuning.
  14. Where about are you planning on setting up?

    Where about are you planning on setting up?
  15. Replies
    3
    Views
    1,887

    Not sure of exact numbers but Modelville runs the...

    Not sure of exact numbers but Modelville runs the spec and Grand National classes 3-4 times a month and I believe attendance is around 12-15 each race.
  16. Replies
    7
    Views
    2,524

    Try changing the gearing to 7/28. If the motor...

    Try changing the gearing to 7/28. If the motor stays spun up it will be easier to drive
  17. Replies
    6
    Views
    1,523

    Looks like an old open arm probably early 90's.

    Looks like an old open arm probably early 90's.
  18. Replies
    3
    Views
    2,269

    Mark are you still developing a tire truer?

    Mark are you still developing a tire truer?
  19. Thread: O Rings

    by dominator
    Replies
    10
    Views
    3,663

    Hi Bill, a local hardware store might have them. ...

    Hi Bill, a local hardware store might have them. If that doesn't work let me know and I'm pretty sure I have some buried in storage I'll pass along to you.
  20. Replies
    9
    Views
    2,392

    Falcon motors are cheap and offer the best...

    Falcon motors are cheap and offer the best handling. As for speed, you can reduce the power to the track till you have a speed you are satisfied with. Falcons typically run anywhere between...
  21. Replies
    13
    Views
    2,954

    I would do as Gary has suggested. Try the 11/38...

    I would do as Gary has suggested. Try the 11/38 or maybe even 11/37. If the Engleman has flat turns then try a 10 to make it more drivable.
  22. Replies
    13
    Views
    2,954

    What kind of track and power are you running? Is...

    What kind of track and power are you running? Is it the same arm only in a different set up?
  23. Replies
    5
    Views
    1,894

    Try gearing 7/27. You may loose a little at the...

    Try gearing 7/27. You may loose a little at the end of the straight but you will make it by under breaking everyone else going into the turns.
  24. Nice looking arms Lou and Bill!

    Nice looking arms Lou and Bill!
  25. Replies
    30
    Views
    10,256

    A sealed motor will only level the playing field...

    A sealed motor will only level the playing field so much. If a particular car is interpreted as not being fast it is usually more related to the chassis/set up of the car or driver than the motor. ...
Results 1 to 25 of 352
Page 1 of 15 1 2 3 4