.

.

Search:

Type: Posts; User: Droidene

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    2,519

    I see there a hole in the fixtures (Bottom and...

    I see there a hole in the fixtures (Bottom and top), i supose these are about 2mm and one can use steel slug to push magnet to side or if anyone like to do wedges.
  2. Replies
    17
    Views
    5,832

    Sorry to hear you having bad experiences with NCP...

    Sorry to hear you having bad experiences with NCP Hobbies, i understand you.
    Scott at PCH is uber nice guy, always a pleasure to shop there.

    There other places to shop, like:

    Hobbies Plus...
  3. Replies
    31
    Views
    8,921

    No worries hehe. Iv seen other place run 13.6...

    No worries hehe.
    Iv seen other place run 13.6 volt with c-can/x-12 runs around 2.6-2.9 and was surprised how fast this proslot fk motor runs and at low cost sealed motor.
    Not sure how much...
  4. Replies
    31
    Views
    8,921

    Ahh ok, not bad for that sort of motor. 2.9s

    Ahh ok, not bad for that sort of motor. 2.9s
  5. Replies
    31
    Views
    8,921

    What kind of track did you guys run on?

    What kind of track did you guys run on?
  6. Replies
    2
    Views
    2,172

    I just saw a youtube i just found. Go Fast...

    I just saw a youtube i just found.
    Go Fast Products Armature Meter

    I have no experience into this, but in this video he had induction as lowest and Resistance as highest.. while you wrote you had...
  7. Thread: Air Gap

    by Droidene
    Replies
    20
    Views
    8,160

    I have testet .528, .530 and .533 with .518 arm....

    I have testet .528, .530 and .533 with .518 arm. (On king track)
    I kinda like .533, .530 aint bad either. With good body setup you can handle car pretty smooth and fast turns.

    Other track that is...
  8. Replies
    17
    Views
    7,194

    There excist other powersupply. Like this one: ...

    There excist other powersupply.
    Like this one:

    e-shop Attan
    0-13V up to 15A
    You can plug in your soldering iron to it (Independent)
    Also a USB connector 5V (Charging your phone)
  9. Replies
    7
    Views
    1,882

    Usual i solder them all, even ball bearing. ...

    Usual i solder them all, even ball bearing.

    For turboflex chassis i use Parma olilite. (Just remember to heat it up to remove oil before solder)
    For JK-25 chassis i use Slick 7 bronze bushing.
    ...
  10. Replies
    19
    Views
    5,746

    Sound like you need a .525 slug to install your...

    Sound like you need a .525 slug to install your magnet in a C-can. (That if your magnet is .155 tick - koford, not sure about those T5, perhap it ticker than koford)
    Anyway, if your magnet is .150...
Results 1 to 10 of 10