Hi.

A new version of LapMaster has now been made available to tracks using the LapMaster hardware.

If you race at such an establishment, and they install the 3.28 version, you should know that the start procedure has been changed slightly.

In previous version the count down was "3, 2, 1, Go" and then power was applied a fraction after the "Go" was pronounced.
The new procedure is "3, 2, 1 [Power and] Go" where power turns on at the same time as the "Go" announcement starts.

Don't get caught out the first time you try this. Don't blame me if your car ends in the barrier before you think the race has started.
Well actual you can blame me, but I will not assume responcibility !

Best regards, Carsten Groennemann.