The ECFS will hold a warm up race for our summer shootout series on June 1st at Smitty J’s raceway ( former H & H raceway) in Hanover PA. We will be running 4 inch stock car and LMP. Remember NO short shaft/cut arms will be allowed for LMP. I will post the rules for the classes below as well as the location of the raceway and start time.

Address: 130 Eisenhower Drive , Hanover Pa

Track : Grandstand with a dark grey surface

Track power : 13 volts

Braid depth : 25 thousandths

Tech for 4 inch stock car will open at 10:30am
Tech will close for 4 inch stock car at 11:00am

The race for 4 inch stock car will start at 11:00am

As soon as 4 inch stock car has ended we will open tech for LMP

4 inch stock car : 3 minutes on 2 minutes off

Chassis - Any flexi stamped steel 4 inch chassis . Bracing is allowed. No aluminum pans are allowed. Chassis must remain in stock configuration . Oilites in the chassis only . 3/32nd axles. No hollow axles. You may jig rear axles for clearance. Tape and lexan as well as lead weight is allowed. Pin tubes are allowed. 047 clearance

Motor - Hawk 7 only

Gears - Any gears. No gears may hang below the chassis.

Body - Any current 4 inch stock car body. Must have three numbers. No added aero. Must have 3D interior and front wheel stickers. Tape and lexan allowed. Must cut on the cut line . Must have a resemblance of a front and rear bumper. Rear end height will not be measured.

Tires - Open tire rule . No minimum size. No speed rubber.

LMP : 3 minutes on 2 minutes off

Chassis - Any flexi stamped steel 4 inch chassis. Bracing is allowed. Aluminum pans are allowed. Chassis must remain in stock configuration . Oilites in the chassis only . 3/32nd axles. No hollow axles. You may jig rear axles for clearance. Tape and lexan as well as lead weight is allowed. Pin tubes are allowed. 047 clearance

Motor - unsealed or sealed Proslot 4002 fk only. Chinese FK arm only. You may change the hardware , brushes and springs. You are allowed to balance , tie and epoxy the arm. You may solder or glue the oilite in the motor. Oilites in motor only. No ball bearings allowed . No Short shaft/cut arms allowed.

Gears - Any gears. No gears may hang below the chassis.

Body - Any current LMP body. No Eurosport bodies allowed. Must have three numbers located anywhere on the body. No added aero. Must have front wheel stickers. Tape and lexan allowed. Rear end height will not be measured. You may cut out the rear of the body. No diaplanes allowed.

Tire - Open tire rule. No minimum size. No speed rubber