Skinners epoxy back in stock

[Bent rim]

Skinners epoxy is now back in stock.

[Mic Byrd]

whats the cure procedure for skinners?

[Ody]

Skinners Info
http://www.slotcartalk.com/slotcarta...ad.php?t=13742

[Bent rim]

Thanks Ody

[Mic Byrd]

thanks couldn't remember temp and times

[John Waller]

What's the best way to get magnets out, other than torching the **** out of them?

John

[Bent rim]

John, I have tried everything. Even using two 1100 degree irons. What makes the epoxy great is magnets do not come out easy. Torching is the only nice way to get them out. Plan on sending magnets out for zapping, after you burn them out.

[oldweirdherald]

Reposted from previous thread here for convenience

Epoxy Instructions

#1 Clean surfaces to be bonded ( lightly sand back of magnets with 400 paper or wire brush with dremel.) Remove any loose magnet dust with magnet putty then wash off with MEK or Acetone solvent. Clean inside of can then cross hatch with exacto blade and wash with MEK or Acetone.

#2 Apply a thin coating to both the magnets and can surfaces to be bonded. Allow 25 minutes for parts to air dry

#3 Place magnets in can, position with v blocks or a slug then place in pre heated oven @ 180 F for 15 minutes. Remove from oven then let cool. Make final magnet adjustments if necessary.

#4 Pre-heat oven to 350 f place setup in oven for 25 minutes
remove, cool and hone to desired gap.


SKINNER