.

.

Results 1 to 11 of 11

Thread: Honing tips for C-can motors

  1. #1
    Join Date
    Jun 2002
    Location
    Wellington, New Zealand
    Posts
    4,540

    Honing tips for C-can motors

    When honing is required for a single magnet c-can motor, what is the ideal increment to use between increasing hone sizes?
    Zippity

    "Rules are written by FEAR; and that Racers are motivated by the Fear that somebody may have something that gives others an Edge." - Rocky Russo



  2. #2
    Join Date
    Jun 2002
    Location
    Iowa
    Posts
    886
    I always tried not to go more than .005 per side with water as the cooler.
    Sincerely,

    Jeff Strause

  3. #3
    Join Date
    Feb 2005
    Location
    Chesapeake, Va.
    Posts
    809
    I have done as much as .010 per side with cutting oil and synthetic 0w-20 with no problems using a Megahone. I've had problems with the Koford hones and limit them to .005 or less.
    I've done so much with so little for so long it seems like I can do anything with nothing at all.

  4. #4
    Join Date
    Sep 2011
    Location
    Long Island,N.Y.
    Posts
    984
    What do you use to turn the hone and at what speed?

  5. #5
    Join Date
    Jun 2002
    Location
    Iowa
    Posts
    886
    I used a drill, preferably 120v and at slot to medium speed.
    Sincerely,

    Jeff Strause

  6. #6
    Join Date
    Jun 2002
    Location
    Home of the 2007 USRA Nats and a pretty fast King Track
    Posts
    2,531
    I also use a drill but a battery operated one. I go slow but vary speed according to how well it's going and the resistance I feel.
    There are "Racers" and there are "Talkers".....which one are you?

  7. #7
    Join Date
    Jan 2014
    Location
    Palmyra
    Posts
    87
    I use my battery powered dermel at a medium speed with water...

  8. #8
    Join Date
    Feb 2005
    Location
    Chesapeake, Va.
    Posts
    809
    I use a variable speed cordless drill. It gives me control over the cutting speed and heat buildup. It's an inexpensive drill I picked up at Harbor Freight.
    I've done so much with so little for so long it seems like I can do anything with nothing at all.

  9. #9
    Join Date
    Nov 2002
    Location
    colorado
    Posts
    62
    A trick I found that made it easier was using liquid Toothpaste and water. Leaves a nice smooth fini8sh and smells good too. Also allows you to take bigger bites if you have a lot of material to remove.
    Clyde-0-Mite

  10. #10
    Join Date
    Jun 2016
    Location
    Nevada City Ca
    Posts
    3
    Also while honing (with water running), I pull the hone threw rather than pushing. Less likely to bend the shaft. I go in .005 increments, .0025 per side for less build up and longer hone life.

    Also I solder the diamond round to the hone shaft, so as not to spin.

  11. #11
    Join Date
    Jun 2004
    Location
    Australia
    Posts
    158
    I use a battery drill while holding the can under running water

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •